Montana AWD V6-3.4L VIN E (2004)
Wiper Control Module: Service and Repair
WIPER MODULE COVER REPLACEMENT
REMOVAL PROCEDURE
1. Open the hood.
2. Remove the hood rear seal part way to gain access to the wiper drive system module cover retainers.
3. Remove the wiper drive system module cover from the pinchweld flange.
4. Remove the wiper drive system module cover from the engine compartment.
INSTALLATION PROCEDURE
1. Position the wiper drive system module cover to the pinchweld flange.
2. Install the wiper drive system module cover to the pinchweld flange, pressing down until fully seated.
3. Install the hood rear seal to the pinchweld flange.
4. Close the hood.
