Montana AWD V6-3.4L VIN E (2004)
Windshield Washer Reservoir: Service and Repair
WASHER SOLVENT CONTAINER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the washer solvent from the washer solvent container.
2. Remove the battery.
3. Disconnect the wiper motor electrical harness from the washer solvent container and position aside.
4. Disconnect the front washer pump electrical connector.
5. Disconnect the rear washer pump electrical connector if equipped.
6. Disconnect the front washer pump hose.
7. Disconnect the rear washer pump hose if equipped.
8. Remove the washer solvent container screws.
9. Remove the washer solvent container from the right inner fender.
INSTALLATION PROCEDURE
1. Position the washer solvent container to the right inner fender.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the washer solvent container screws.
Tighten
Tighten the screws to 6 N.m (53 lb in).
3. Connect the rear washer pump hose if equipped.
4. Connect the front washer pump hose.