Montana SV6 V6-3.9L (2007)
2. Align the rear bumper fascia (2) to the rear bumper fascia outer support.
3. Align the rear bumper fascia outer retainer (4) to the body.
Notice: Refer to Fastener Notice.
4. Install the palnut to the rear bumper fascia outer retainer.
Tighten the palnut to 2 N.m (18 lb in).
5. Install the push-in retainers (3) to the upper and lower rear bumper fascia.
6. Install the screws (5) at the right and left wheel well to the rear bumper fascia.
Tighten the rear bumper fascia wheel well screws to 3 N.m (26 lb in).
7. Connect the electrical connection (1) to the rear object sensor harness, if equipped.
8. Close the liftgate.
