Montana SV6 V6-3.9L (2007)
Center Sliding Door Roller: Service and Repair
Rear Side Door Center Roller Bracket Replacement
Removal Procedure
Important: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door
modules (PSDM) will be interrupted and both PSDs will be inoperative.
1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
2. Open the sliding door in order to gain access to the center roller bracket pin.
3. Support the rear of the sliding door.
4. Remove the pin (1) from the center roller bracket (2).
5. Position the center roller bracket to the front radius of the sliding door center track.
6. Release cable tension.
7. Remove the cables (1, 2) from the rear roller bracket (power sliding door only).
