Montana SV6 V6-3.9L (2007)
11. Install the front pulley bolts (7, 9).
Tighten the bolts to 10 N.m (89 lb in).
12. Install the front pulley nut (8).
Tighten the nut to 10 N.m (89 lb in).
Important: Ensure that the power sliding door cable barrels are properly installed into the sliding door center roller bracket, body side,
cable retaining fingers located on the roller bracket.
13. Adjust the PSD cable tension. refer to Rear Side Door Actuator Cable Tension Adjustment.
14. Manually open and close the sliding door in order to verify that:
* Latch/unlatch function operates
* Cable assembly is correctly positioned in the center track
* The door fits, check all external door gaps
* Ensure the lower roller track is clear of any foreign material and debris.
15. Install the right rear quarter lower trim panel.
Important: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be
operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. refer to Rear Side Door Actuator
Control Module Programming and Setup.
16. Enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.
