Montana SV6 V6-3.9L (2007)
7. Remove the spacer ring (1), spider assembly (2), spacer ring (3) (if equipped) using J 8059, and tripot boot (4). Discard the boot and rings.
8. Clean the halfshaft bar (5). Use a wire brush in order to remove any rust in the boot mounting area (grooves).
9. Inspect the needle rollers, needle bearings, and trunnion. Check the tripot housing for unusual wear, cracks, or other damage. Replace any
damaged parts with the appropriate kit.
Installation Procedure
Important: Place a towel in the vise before inserting the halfshaft.
1. Mount the halfshaft into a vise.
2. Place the new small eared clamp (2) onto the small end of the joint seal (1). Slide the joint seal (1) and the eared clamp (2) onto the halfshaft bar.
3. Position the small end of the joint seal (1) into the joint seal groove (3) on the halfshaft bar.
