Montana SV6 V6-3.9L (2007)
5. Install the washer and the brake booster pushrod retaining clip.
Notice: Proper stoplamp switch adjustment is essential. Improper stoplamp switch adjustment may cause brake drag, heat buildup and
excessive brake lining wear.
6. Calibrate the brake pedal position sensor.
7. Install the knee bolster.
8. Rotate the engine back and install the engine mounts, bolts, and nuts.
9. Install the brake booster vacuum hose to the vacuum brake booster check valve.
10. Install the BPMV and bracket assembly.
11. Install the brake master cylinder and connect the brake lines.
12. Connect the fluid level sensor switch on the master cylinder.
13. Install the fuel pipes to the pipes shock tower.
14. Install the heater hose to the coolant cross over pipe.
15. Install the air cleaner assembly.
16. Install the ECM.
17. Install the ECM cover.
18. Install the left front cross brace.
19. Install the coolant recovery reservoir.
20. Fill and bleed the cooling system.
21. Bleed the hydraulic brake system.
