Montana SV6 V6-3.9L (2007)
2. If the oil filter adapter was replaced, lubricate the oil pressure sensor seal with clean engine oil.
3. Apply sealant to the threads of the oil pressure sensor.
Notice: Refer to Fastener Notice.
4. Install the oil pressure sensor to the oil filter adapter.
Tighten the sensor to 16 N.m (12 lb ft).
5. Apply sealant to the bolt/stud threads, if required.
6. Position the NEW oil filter gasket and the oil filter adapter to the engine block.
7. Install the oil filter adapter bolts and stud.
Tighten the bolts and stud to 25 N.m (18 lb ft).
