Montana SV6 V6-3.9L (2007)
5. Remove the HO2S electrical connector from the ignition coil bracket.
6. Remove the HO2S from the exhaust manifold.
Installation Procedure
Important: A special anti-seize compound is used on the HO2S threads. The compound consists of liquid graphite and glass beads. The tends to
burn away, but the glass beads remain, making the sensor easier to remove. New or service replacement sensors already have the compound
applied to the threads. If the sensor is removed from an exhaust component and if for any reason the sensor is to be reinstalled, the threads
must have anti-seize compound applied before reinstallation.
1. If re-installing the old sensor, coat the threads with anti-seize compound P/N 12377953, or equivalent.
Notice: Refer to Fastener Notice.
2. Install the HO2S to the exhaust manifold.
Tighten the sensor to 42 N.m (31 lb ft).
