Montana SV6 V6-3.9L (2007)
Caution: In order to reduce the risk of fire and personal injury that may result from a fuel leak, always replace the fuel sender gasket
when reinstalling the fuel sender assembly.
1. Position a NEW fuel tank module seal (7) on the fuel tank.
Important: Care should be taken not to fold over or twist the fuel pump strainer when installing the fuel tank module assembly, as this
will restrict fuel flow. Also, ensure that the fuel pump strainer does not block full travel of float arm.
2. Install the fuel tank module (2) into the fuel tank.
Important: Always replace the fuel tank module seal when installing the fuel tank module assembly. Replace the lock ring if necessary.
Do not apply any type of lubrication in the seal groove.
Ensure the lock ring is installed with the correct side facing upward. A correctly installed lock ring will only turn in a clockwise direction.
3. Use the J 45722 in order to install the fuel tank module lock ring. Turn the fuel sender lock ring in a clockwise direction.
4. Connect the EVAP quick connect fittings to the module.
5. Connect the fuel feed pipe quick connect fitting to the module.
6. Connect the fuel tank harness electrical connectors to the fuel tank module.
7. Install the fuel tank.
