Montana SV6 V6-3.9L (2007)
2. Remove the ELC sensor link (1) from the ball studs on the sensor and control arm.
Installation Procedure
1. Position the ELC sensor link (1) to the ball studs on the sensor and control arm.
2. Press the ELC sensor link ends onto the ball studs until fully seated.
3. Lower the vehicle.
Automatic Level Control Sensor Link Replacement (Twist Axle)
Automatic Level Control Sensor Link Replacement (Twist Axle)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.