Montana SV6 V6-3.9L (2007)
Notice: Refer to Fastener Notice.
6. Install the frame front bolts (2).
Tighten the bolts to 130 N.m (96 lb ft).
7. Install the frame straps (5) and bolts (3).
Tighten the bolts to 50 N.m (37 lb ft).
8. Install the frame rear bolts (4).
Tighten the bolts to 240 N.m (177 lb ft).
9. Remove the alignment pins from the frame.
10. Install the transaxle mount nuts.
11. Install the engine mount nuts.
12. Install the wheel speed sensor wiring harnesses to the lower control arms.
13. Connect the wheel speed sensor electrical connectors.
14. Install the lower ball joints to the steering knuckles.
15. Install the power steering cooler pipe to the frame.
16. Install the front engine splash shield.
17. Install the power steering gear to the frame.
18. Install the power steering gear bolts.
19. Install the power steering gear heat shield.
20. Install the stabilizer shaft.
21. Install both tie rod ends to the steering knuckles.
22. Install the front fender liner.
23. Install the front tires and wheels.
24. Lower the vehicle.
25. Remove the engine support fixture.
26. Inspect the front wheel alignment and adjust the toe angle if necessary.
