Montana SV6 V6-3.9L (2007)
Notice: Refer to Fastener Notice.
5. Install the valve body bolts (374, 381, 384).
*
Tighten the M6 X 1.0 X 20 bolt to 8 N.m (70 lb in).
*
Tighten the M6 X 1.0 X 30 bolt to 12 N.m (106 lb ft).
*
Tighten the M6 X 1.0 X 45 bolt to 12 N.m (106 lb in).
*
Tighten the M6 X 1.0 X 55 bolt to 12 N.m (106 lb in).
*
Tighten the M6 X 1.0 X 60 bolt to 12 N.m (106 lb in).
*
Tighten the M6 X 1.0 X 65 bolt to 12 N.m (106 lb in).
*
Tighten the M6 X 1.0 X 85 bolt to 12 N.m (106 lb in).
*
Tighten the M6 X 1.0 X 95 bolt to 16 N.m (12 lb ft).
*
Tighten the M8 X 1.25 X 90 bolt to 25 N.m (18 lb ft).
Important: Do NOT use impact type tools on the valve body or on the oil pump.
6. Install the oil pump.
7. Install the case side cover.
Important: It is recommended that the transmission adaptive pressure (TAP) information be reset. Resetting the TAP values using a scan
tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or
transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are
learned.
8. Reset the TAP values. Refer to Transmission Adaptive Functions.
