pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Deployment Outside Vehicle - Steering Wheel Module, I/P Module, And Side Impact Module|Page 12758 > < Deployment Outside Vehicle - Steering Wheel Module, I/P Module, And Side Impact Module|Page 12756
Page 13
background image

59. Bend flat the twisted connection.
60. Secure and insulate the connection using electrical tape.

61. Twist together, bend, and tape the remaining connector wire lead to the remaining deployment wire.
62. Connect the deployment harness to the side impact module RF.

63. Route the deployment harness out of the passenger side of the vehicle.
64. Completely cover the windshield and front door window openings with a drop cloth.
65. Stretch out all of the deployment harness wires on the left and right side of the vehicle to their full length.
66. Deploy each deployment loop one at a time.
67. Place a power source, 12-volt minimum/2-amp minimum, i.e., a vehicle battery, near the shorted end of the harnesses.
68. Separate the one set of wires and touch the wires ends to the power source in order to deploy the inflator modules, doing one module at a time.
69. Disconnect the deployment harness from the power source and twist the wire ends together.
70. Continue the same process with the remaining deployment harnesses that are available.
71. Remove the drop cloth from the vehicle.
72. Disconnect all harnesses from the vehicle.
73. Discard the harnesses.
74. Scrap the vehicle in the same manner as a non-SIR equipped vehicle.
75. If one or all of the inflator modules did not deploy, perform the following steps to remove the undeployed modules from the vehicle:

-

If the steering wheel module did not deploy, refer to Inflatable Restraint Steering Wheel Module Replacement.

-

If the I/P module did not deploy, refer to Inflatable Restraint Instrument Panel Module Replacement.

-

If the side impact module (left and/or right) did not deploy, refer to Inflatable Restraint Side Impact Module Replacement - Front.

76. Call Technical Assistance Group.

Deployment Procedures

DEPLOYMENT PROCEDURES

The inflator module can be deployed inside or outside of the vehicle. The method used depends upon the final disposition of the vehicle. Review the
procedures in order to determine which will work best in a given situation.

Steering Wheel Module Replacement

INFLATABLE RESTRAINT STEERING WHEEL MODULE REPLACEMENT

Deployment Outside Vehicle - Steering Wheel Module, I/P Module, And Side Impact Module|Page 12758 > < Deployment Outside Vehicle - Steering Wheel Module, I/P Module, And Side Impact Module|Page 12756