pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Throttle Valve - Revised Diagnosis Using Pressure Gauge|Page 3222 > < Throttle Valve - Revised Diagnosis Using Pressure Gauge
Page 2
background image

^

Warm up engine to normal operating temperature.

^

Run engine at 1000 rpm.

^

With gear selector in "Park", note oil pressure. (NOTE: Remaining steps do not apply to the THM 180, 350, 400 or 440-T4. Refer to the
appropriate Service Manual for line pressure diagnosis procedures.)

^

Place gear selector in "Drive". Oil pressure should be equal or not more than 10 psi (69 kPa) higher than in "Park".

^

Check the T.V. system's line pressure regulation by not increasing the engine's throttle opening while manually pulling the T.V. cable its full length
of travel and reading gage. Oil pressure should steadily increase as cable is pulled out and decrease smoothly as cable is returned to original
position. Refer to Figure 1 for pressure ranges.

--

If oil pressure does not increase or gage reading bounces unsteadily, inspect the throttle lever and bracket assembly on the control valve
assembly. Check that the T.V. exhaust valve lifter rod is not distorted and not binding in the control valve assembly or spacer plate. The
T.V. exhaust check ball must move up and down as the lifter does. Also, be sure the lifter spring holds the lifter rod up against the
bottom of the control valve assembly. Make sure T.V. plunger does not stick at any position of travel.

^

Check T.V. exhaust valve lifter rod and check ball ("fail-safe") system. With engine at idle, disconnect T.V. cable at throttle linkage. Line pressure
should increase to maximum. If line pressure does not increase, inspect the parts as described above.

^

Stop engine for at least 30 seconds to take T.V. system out of "fail-safe" mode. Connect T.V. cable, adjust according to the appropriate Service
Manual, and repeat line pressure checks in "Park" and "Drive" ranges. If T.V. system does not come out of "fail-safe" mode (pressure remains
high), inspect the parts as described above.

TRANSMISSION/

MINIMUM

MAXIMUM

TRANSAXLE

PSI (kPa)

PSI (kPa)

125C

55-85 (379-586)

100-175 (689-1207)

200C

65-80 (448-552)

120-145 (827-1000)

200-4R

50-75 (345-517)

110-170 (758-1172)

700-R4

55-75 (379-517)

115-200 (793-1379)

Figure 1 - T.V. PRESSURE RANGE CHART

NOTE:

For reference only -- for specific values refer to the appropriate Service Manual.

Throttle Valve - Revised Diagnosis Using Pressure Gauge|Page 3222 > < Throttle Valve - Revised Diagnosis Using Pressure Gauge