Solstice L4-2.0L Turbo (2008)
Condition # 6
The customer may comment about a weep from joint # 1 (water runs down the inside of the glass) or a leak from the # 1 joint.
Cause # A
Make sure the push pin retainer is straight in the top corner of the "A" pillar of the windshield. If the pin is on a slight angle the weatherstrip will not
align properly with the top weatherstrip.
Adjust the weatherstrip up or down so that the pin is straight in the "A" pillar.
Important:
A weep at the # 1 or # 2 joint may be corrected by cleaning the glass then apply a thin coat of Rain X or Aqupal on the top inside and top edge of the
door glass. This will condition the weatherstrip.
Cause # B
The door glass may not be high enough in the opening and not closing the gap in joint # 1.
Correction # B
Mark the glass with a grease pencil and adjust the front of the glass 2 mm (3/16 in) upward or forward. Make sure that the stud stays in the top of the
adjustment slot. This slot controls the tip in at the top of the glass.
Cause # C
