Solstice L4-2.0L Turbo (2008)
Notice:
Two (2) technicians are required to perform Steps 7-10. To avoid part damage, ensure that a new washer is installed with the new bolt. If the
seat track contacts the seat adjuster bolt, remove the bolt and re-install the bolt using an additional washer. Do NOT use more than two
washers with the new bolt.
7.
Insert a new washer and bolt into the front and/or rear inboard seat adjuster stud hole(s).
8.
Lower the vehicle.
9.
Using a torque wrench, tighten the front and/or rear inboard seat adjuster nuts (driver and passenger seat).
Tighten
Tighten the front and/or rear inboard seat adjuster nut(s) to 45 N.m (33 ft-lb).
Important:
The seat back should be in the upright position and not the fully reclined position for the seat track to achieve the full rear position.
10.
Test the function of the seat. Sit in the seat and adjust the seat to the full forward and rearward positions.
^
If the rear inboard seat adjuster bolt contacts the seat track and limits the range of seat adjustment, remove the seat bolt and add one additional
washer to the seat bolt. Use no more than two washers to adjust the clearance between the seat track and seat adjuster bolt. Perform Steps 7-10
again.
^
If the seat can be moved to the full forward and rearward positions without contact, no further action is required.
