Solstice L4-2.0L Turbo (2008)
Seat Track: All Technical Service Bulletins
Audio System - Speaker Pop When Exiting Vehicle
TECHNICAL
Bulletin No.: 08-08-44-007A
Date: April 02, 2008
Subject:
Static Pop Noise From Speakers While Exiting Vehicle (Install Spring Washer)
Models:
2007-2008 Pontiac Solstice
2007-2008 Saturn SKY
2007-2008 Opel GT
2008 Daewoo G2X
with Leather Seat Covers and Vertical Power Seat Adjuster (RPO AF2) and Built Prior to 9/24/07
Supercede:
This bulletin is being revised to add the 2007-2008 Saturn SKY. Please discard Corporate Bulletin Number 08-08-44-007 (Section 08 - Body and
Accessories).
Condition
Some customers may comment on a static pop noise from the speakers while exiting the driver seat.
Cause
This condition may be caused by a poor ground path between the seat frame and the power seat adjuster.
Correction
Install a spring washer on the driver seat track assembly. Please follow the directions below to install the spring washer on the front of the right side
(inboard) power seat adjuster link arm.
1.
Lower the top.
2.
Remove the left front door sill plate. Refer to Door Sill Plate Replacement in SI.
3.
Remove the driver side front seat assembly. Refer to Seat Replacement in SI.
4.
Place the seat assembly on a clean work bench with the right (inboard) side of the seat track facing up.
5.
Unhook the seat cover J-channel from the front and side of the seat cushion frame.
6.
Place a support block (1) between the seat track and the seat cushion to gain access to the seat adjuster link arm TORX(R) screw (2).
7.
Remove the 40 mm TORX(R) head screw from the seat adjuster link.
