Solstice L4-2.0L Turbo (2008)
2.
Pull the wrench until it clicks.
^
If the wrench clicks at or less than 45 degrees, the stud is good.
^
If the wrench pulls beyond 45 degrees and does not click, the stud is suspect and needs to be replaced.
3.
Place the 50 Nm wrench on the rear driver's side inboard stud and rotate the handle to the rear trim panel.
4.
Pull the wrench until it clicks. Use the rear edge of seat as guide.
^
If the wrench clicks at or less than 45 degrees, the stud is good.
^
If the wrench pulls beyond 45 degrees and does not click, the stud is suspect and needs to be replaced.
