Solstice L4-2.0L Turbo (2008)
Remove the rear fascia and clean the area effected and seal with urethane.
Door Glass Adjustment
1.
Open the door and raise the glass to the full up position.
2.
Close the door.
3.
Loosen the door glass and with the use of a helper push the door glass in the opening to achieve the dimensions listed in the steps below.
4.
Set the door glass so there is 3 mm (0.16 in) seal wink over of the seal at location # 1.
5.
Set the door glass so there is 3 mm (0.20 in) seal wink over of the seal at locations # 2 & 3.
6.
Ensure that the top edge of the glass fully contacts the primary bulb of the rear of the weatherstrip at locations # 4 & 5.
7.
The rear edge of the door glass should cover the flap at a minimum along the radius at location # 5.
8.
Make sure the front edge of the door glass does not trap the "A" pillar weatherstrip when the door is opened or closed.
