Solstice L4-2.0L Turbo (2008)
Important: Prior to installing the water pump, read the entire procedure. This will help avoid balance shaft chain re-timing and ensure
proper sealing.
1. Install a NEW water pump O-ring seal.
Important: A guide pin can be created to aid in water pump alignment. Use a M 6 m x 6 mm stud. Thread the pin into the water pump
sprocket.
2. Using the guide pin, align the pin with the water pump holding tool.
3. Position the water pump against the engine block and hand tighten the water pump bolts.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Install the inner water pump sprocket bolts. After 2 are snug, remove the guide pin and install the 3rd bolt.
Tighten the bolts to 25 N.m (18 lb ft).
5. Tighten the water pump sprocket bolts last.
Tighten the bolts to 10 N.m (89 lb in).
6. Remove the J 43651 (1) .
