Solstice L4-2.0L Turbo (2008)
Tie Rod Boot: Service and Repair
Rack and Pinion Boot Replacement
Tools Required
J 22610 Keystone Clamp Pliers
Removal Procedure
1. Remove the rack and pinion outer tie rod end. Refer to Rack and Pinion Outer Tie Rod End Replacement (See: Tie Rod End/Service and Repair) .
2. Remove the steering linkage inner tie rod nut (5) from the steering linkage inner tie rod.
3. Remove the steering gear boot clamp (4).
4. Cut and discard the steering gear boot clamp (2).
Important: After removing the boot, inspect the inner tie rod for evidence of corrosion or contamination. If none is evident, continue
with the repair. If corrosion or contamination is evident, replace the steering gear.
5. Remove the steering gear boot (3) from the steering gear (1).
Installation Procedure
1. Apply grease to the steering linkage inner tie rod (2) and the steering gear (1) prior to installing the steering gear boot (3).