Solstice L4-2.0L Turbo (2008)
Transmission Position Switch/Sensor: Service and Repair
Manual Shift Shaft Position Switch Replacement
Tools Required
J 44767 Seal Installer
Removal Procedure
1. Remove the transmission. Refer to Transmission Replacement (See: Service and Repair/Removal and Replacement) .
2. Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement (See: Service and Repair/Removal
and Replacement) .
3. Place the transmission in neutral by rotating the transmission shift shaft clockwise 2 clicks.
Important: Replace the shaft seal only if leaking.
4. Using a small screwdriver, remove and discard the shaft seal.
Important: Replace the cup plug only if leaking.
5. Using a small screwdriver, remove and discard the cup plug.
6. Disconnect the electrical connector from the manual shift shaft position switch.
7. Using a suitable pin punch (1), remove the manual shift shaft position switch retaining pin (2).
