Solstice L4-2.0L Turbo (2008)
3. Install the J 43482 in order to support the clutch cover to the flywheel assembly.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Tighten the clutch cover to flywheel bolts in the sequence shown.
Tighten the bolts to 30 N.m (22 lb ft).
5. Recheck each bolt torque using the tightening sequence.
6. Remove the J 43482 .
Important: Excessive amounts of lubricant on the input shaft splines may contaminate the clutch disc and cause clutch shudder.
7. Lubricate the inside diameter of the bearing.
8. Install the transmission. Refer to Transmission Replacement (With Z0K) (See: Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement/Transmission Replacement (With Z0K))Transmission Replacement (Without Z0K) (See: Manual Transmission/Transaxle/Service
and Repair/Removal and Replacement/Transmission Replacement (Without Z0K)) .
9. Bleed the hydraulic system. Refer to Hydraulic Clutch Bleeding (See: Clutch Hydraulic System/Service and Repair) .
10. Connect the negative battery cable.
