Solstice L4-2.0L Turbo (2008)
2. Install the output shaft flange dirt defector to the output shaft flange if previously removed.
3. Install the output shaft flange.
4. Install the O-ring seal to the output shaft flange.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
5. Install the output shaft nut.
Tighten the nut to 113 N.m (83 lb ft).
6. Use a hammer and a punch to crimp the output shaft nut to the output shaft.
7. Check the transmission fluid level. Add if necessary. Refer to Transmission Fluid Replacement (See: Service and Repair/Removal and
Replacement/Transmission Fluid Replacement) .
8. Install the rear propeller shaft. Refer to Propeller Shaft, Differential, and Driveline Support Replacement (See: Drive/Propeller Shafts, Bearings
and Joints/Drive/Propeller Shaft/Service and Repair/Propeller Shaft, Differential, and Driveline Support Replacement) .
