Solstice L4-2.4L (2007)
Convertible Top Canvas: All Technical Service Bulletins
Body - Abnormal Convertible Top Wear
TECHNICAL
Bulletin No.: 08-08-67-010B
Date: June 18, 2009
Subject: Convertible Top Wear (Replace Convertible Top and Folding Top Side Rear Weatherstrips)
Models:
2007 Pontiac Solstice
2007 Saturn SKY
2007 Opel GT
Built Prior to March 2007
Attention:
This bulletin only pertains to vehicles built with plan B tops. Refer to Corporate Bulletin Number 06-08-67-009A for more information.
Supercede:
This bulletin in being revised to add the Saturn SKY to the models information and to inform the technician that the wear clips are included with the
weatherstrip kit. Please discard Corporate Bulletin Number 08-08-67-010A (Section 08 - Body and Accessories).
Condition
Some customers may comment that the convertible top is showing wear on the underside of the roof.
Cause
This condition may be due to the metal reinforcement in the folding top side rear weatherstrip protruding out and making contact with the top during the
opening and closing cycles.
Correction
Replace the convertible top cover and the folding top side rear weatherstrip (left and right). Refer to Folding Top Cover Replacement in SI. These
instructions supplement the top cover replacement process.
Note
Perform Step 2 before the old top cover is removed and Steps 3 and 4 with the old top cover completely removed.
1. Place a fender cover or seat cover over the seats to protect them from dirt and debris.
2. Before removing the folding top side front weatherstrip retainer. Mark the location with a paint pen for alignment.
3. With a paint pen, mark the rear of the 1-2 bow. This is the triangle area highlighted in white.
Important
The 1-2 bow of the convertible top is made out of magnesium and a die grinder should not be used to remove the material.
4. With a utility knife, scar the number 1-2 bow (shown as the highlighted area triangular zone in the graphic above). Make several passes in the
material. Use vise-grip pliers to remove the piece.
5. Use a flat file and smooth any sharp edges from the bow.
