Solstice L4-2.4L (2007)
Tire Mounting and Dismounting
Tire Mounting and Dismounting
Notice: Use a tire changing machine in order to dismount tires. Do not use hand tools or tire irons alone in order to remove the tire from the wheel.
Damage to the tire beads or the wheel rim could result.
Notice: Do not scratch or damage the clear coating on aluminum wheels with the tire changing equipment. Scratching the clear coating could cause the
aluminum wheel to corrode and the clear coating to peel from the wheel.
Notice: Use care when positioning the tire and wheel assembly on the tire changer. The upper/lower bead breaker or tire changing tools may
damage the TPM sensor. To prevent damage, position the valve stem/sensor 90 degrees away from the two bead breakers. For rim clip tire
changers, position the bead breakers approximately 180 degrees away from the valve stem/sensor.
Notice: Damage to either the tire bead or the wheel mounting holes can result from the use of improper wheel attachment or tire mounting
procedures. It takes up to 70 seconds for all of the air to completely exhaust from a large tire. Failure to follow the proper procedures could cause
the tire changer to put enough force on the tire to bend the wheel at the mounting surface. Such damage may result in vibration and/or shimmy, and
under severe usage lead to wheel cracking.
1. Deflate the tire completely.
Important: Rim-clamp European-type tire changers are recommended.
2. Use the tire changer in order to remove the tire from the wheel.
3. Use a wire brush or coarse steel wool in order to remove any rubber, or corrosion from the wheel bead seats.
Notice: When mounting the tires, use an approved tire mounting lubricant. DO NOT use silicon or corrosive base compounds to lubricate the tire
bead and the wheel rim. A silicon base compound can cause the tire to slip on the rim. A corrosive type compound can cause tire or rim
deterioration.
4. Apply GM P/N 12345884 (Canadian P/N 5728223) or equivalent to the tire bead and the wheel rim.
Important: If the vehicle is equipped with directional tread tires, ensure that the directional arrow on the tire is mounted to the outboard
side of the rim in the direction of forward rotation when installed onto the vehicle.
5. Use the tire changer in order to install the tire to the wheel.
Caution: To avoid serious personal injury, do not stand over tire when inflating. The bead may break when the bead snaps over the
safety hump. Do not exceed 275 kPa (40 psi) pressure when inflating any tire if beads are not seated. If 275 kPa (40 psi) pressure will not
seat the beads, deflate, relubricate the beads and reinflate. Overinflation may cause the bead to break and cause serious personal injury.
6. Inflate the tire to the proper air pressure.
7. Ensure that the locating rings are visible on both sides of the tire in order to verify that the tire bead is fully seated on the wheel.
Extended Mobility Tires Replacement
Extended Mobility Tires Replacement
Standard Extended Mobility Tires (EMT) are capable of operating for limited distances at very low or zero tire inflation. Because of this capability, the
Tire Pressure Monitoring (TPM) system is standard with extended mobility tires. Check the inflation of the tires if the LOW/FLAT TIRE indicator is
ON. Inspect the affected tire for possible repair or replacement if any of the following occurs:
*
Inspect the affected tire if the LOW/FLAT TIRE indicator reappears.
*
Inspect the affected tire if an EMT has been operated at a pressure significantly below 172 kPa (25 psi).
It is recommended that repair or replacement of extended mobility tires be made only by an authorized tire dealer. Extended mobility tires are designed
to be used only with original equipment wheels equipped with the low tire pressure warning system (TPM).
