Solstice L4-2.4L (2007)
1. Spread the grease onto the ball tracks, the balls, the cage, and the inner race.
2. Spread the remainder of the grease into the bottom of the outer race.
2. Remove the inner joint from the bench vise.
3. Wrap a shop towel around the axle shaft.
4. Place the wheel drive shaft horizontally in a bench vise.
5. Install a new small seal retaining clamp onto the axle shaft.
6. Install the seal onto the axle shaft.
7. Install the New narrow retaining ring to the outer narrow ring groove (2) at the end of the wheel drive shaft.
8. Install the New wide spacer ring to the wide ring groove of the wheel drive shaft (1).
9. Position the outer joint horizontally.
10. Engage the inner race splines onto the axle shaft splines.
11. Compress the axle shaft ring spacer.
1. Press the end of the retaining ring, using a flat-bladed tool, into the axle shaft groove while firmly pressing the inner joint onto the axle shaft.
2. Continue to work around the retaining ring, until it is compressed.
