Solstice L4-2.4L (2007)
Important: The seal retaining clamp must not be over-tightened or under-tightened.
16. Using the J 42572 (1), crimp the small seal retaining clamp.
Tighten the small seal clamp until the base of the omega ohm shape has a gap of 1 mm (0.039 in).
The clamping hold time must be no less than 2 seconds.
Important: The inner boot must not be dimpled, stretched, or out of shape in any way. If necessary, equalize the air pressure in the inner
boot and shape properly by hand.
17. Position the large seal retaining clamp (1) onto the seal (2).
18. Position the seal and large retaining clamp to the joints can boot groove (3) as shown.
19. Measure the distance (1) between the seal edges.
88.6 mm (3.50 in)
