pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Seatback Striker, Rear - Add Remove/Install Procedure|Page 10456 > < Seats - Rattle/Squeak From Passenger Side Rear Seatback|Page 10450
Page 1
background image

Seat Back: All Technical Service Bulletins
Seatback Striker, Rear - Add Remove/Install Procedure

File In Section: 10 - Body 

Bulletin No.: 83-10-95

Date: February, 1998

SERVICE MANUAL UPDATE

Subject: 
Section 10-13 - Add Remove/Install Procedure for Rear Seatback Striker

Models: 
1995-98 Chevrolet Cavalier (Convertible Only)
1995-98 Pontiac Sunfire (Convertible Only)

This bulletin is being issued to add a new service procedure to Section 10-13 of the Service Manual.

All 1995-98 Chevrolet Cavalier and Pontiac Sunfire convertibles each have four shims (two per attached bolt) located behind the rear seat striker. The
striker is a carryover from the coupe; however, shimming the striker is convertible only.

Please add the following procedure to Section 10-13 of the Service Manual.

Rear Seatback Striker (Convertible Only)

Figure 1

Remove or Disconnect

1.

Rear seatback.

2.

Boot center section.

3.

Rear shelf carpet from the bottom of the closeout panel, as necessary.

4.

Bolts, seat striker and the two shims.

Install or Connect

1.

Two shims, seat striker and the bolts. 

Seatback Striker, Rear - Add Remove/Install Procedure|Page 10456 > < Seats - Rattle/Squeak From Passenger Side Rear Seatback|Page 10450