Sunfire L4-138 2.3L DOHC VIN D MFI (1995)
information may be inserted with a typewriter or a ball point pen.
Each"Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in by the
customer for periodic servicing. When installing the Campaign Identification Label, be sure to pull the tab to allow adhesion of the clear protective
covering. Additional Campaign Identification Labels can be obtained from VISPAC Incorporated by calling 1-800-269-5100 (Monday-Friday, 8:00 a.m.
to 4:30 p.m EST). Ask for Item Number S-1015 when ordering.
Apply the "Campaign Identification Label" only on a clean, dry surface.
Claim Information
Submit a Product Campaign Claim with the information indicated below:
*
REPAIR
PART
FAILED
PARTS
LABOR
LABOR
PERFORMED
COUNT
PART NO.
ALLOW
CC-FC
OP
HOURS
INSPECT ONLY
0
# # # #
**
MA-98
V9988
0.2
FOR PROPER
HAZARD LAMP
FUNCTION
INSPECT FOR
1
# # # #
**
MA-96
V9998
0.4
PROPER HAZARD
LAMP FUNCTION
AND REPLACE
HAZARD/MULTI-
FUNCTION SWITCH
* For Campaign Administrative Allowance, add 0.1 hours to the "Labor Hours".
** The "Parts Allowance" should be the sum total of the current GMSPO Dealer Net price plus 40% for the hazard/multifunction switch needed to
complete the repair.
Warranty claims for any necessary bulb replacement and/or wiring repairs (see step 2 of the service procedure) should be submitted separately as regular
(non-campaign) warranty claims.
Refer to the General Motors Corporation Claims Processing Manual for details on Product Campaign Claim Submission.
Owner Letter
January, 1997
Dear <Division(s)> Customer:
This notice is sent to you in accordance with the requirements of the National Traffic and Motor Vehicle Safety Act.
REASON FOR THIS RECALL:
General Motors has decided that certain 1995 and 1996 "J" and "N" model vehicles fail to conform to Federal Motor Vehicle Safety Standard (FMVSS)
108: "Lamps, Reflective Devices, and Associated Equipment". These vehicles may exhibit a condition in which the front and/or rear hazard warning
lamps (four-way flashers) do not flash when the hazard switch is activated.
Interior telltale lamps will still flash if the rear hazard lamps are inoperative but front hazard lamps are operative. The interior telltale lamps will not flash
if the front hazard lamps are inoperative.
WHAT WILL BE DONE:
To correct this condition and in order to comply with FMVSS 108, vehicle owners or dealers will inspect for proper function of the hazard warning
lamps. If necessary, dealers will replace the hazard lamp switch. This service will be performed for you at no charge.
INSPECTION:
You may check the hazard warning lamps for correct function yourself or ask your [Chevrolet/Oldsmobile/Pontiac] dealer to perform the check for you.
If you want to check the hazard warning lamps yourself and possibly save a trip to your dealer, please follow the procedure attached to this letter.
HOW LONG WILL THE REPAIR TAKE?:
If you take your vehicle to your [Chevrolet/Oldsmobile/Pontiac] dealer for inspection/parts replacement, labor time necessary to perform this service
correction is approximately 25 minutes. Additional time may be required to schedule and process your vehicle. If your dealer has a large number of
vehicles awaiting service, this additional time may be significant. Please ask your dealer if you wish to know how much additional time will be needed.
CONTACTING YOUR DEALER:
