pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Service Engine Now Light - On or A No-Start Condition|Page 4228 > < Service Engine Now Light - On or A No Start Condition|Page 4223
Page 1
background image

Engine Control Module: All Technical Service Bulletins
Service Engine Now Light - On or A No-Start Condition

File In Section: 6E - Engine Fuel & Emission 

Bulletin No.: 83-65-39

Date: March, 1998

Subject:
Service Engine Now Light On or a No Start Condition (Remove PCM and Seal with Silicone Sealer)

Models:
1995-96 Chevrolet Cavalier
1995-96 Pontiac Sunfire

Condition
Some owners may comment that their Service Engine Now light is On or that the vehicle will not start.

Cause
Condition may be due to water leaking into the PCM.

Correction

1.

Remove the PCM following the procedure in the 1995-96 J-Car Service Manual.

2.

Thoroughly clean the PCM flange with a wire brush.

3.

Apply GE Goodwrench RTV Silicone Sealer (P/N 01052915) to the entire sealing area and case joint of the PCM. (See arrows in Figure 1).

4.

Apply GE Goodwrench RTV Silicone Sealer (P/N 01052915) to the access cover when applicable.

5.

Allow to set up and reinstall the PCM following the procedure in the 1995-96 J-Car Service Manual.

6.

If the vehicle requires a new or remanufactured PCM, this procedure must be performed before the new PCM is installed!

Parts Information

P/N

Description

01052915

GE Goodwrench RTV Silicone Sealer 

Parts are currently available from GMSPO. 

Warranty Information

Service Engine Now Light - On or A No-Start Condition|Page 4228 > < Service Engine Now Light - On or A No Start Condition|Page 4223