Sunfire L4-138 2.3L DOHC VIN D MFI (1995)
Throttle Position Sensor: Testing and Inspection
SCAN TOOL TESTING
A scan tool displays throttle position in volts. The scan tool should display 0.20 volt to 0.90 volt with the throttle closed (as at idle) and ignition
"ON." Voltage should increase at a steady rate as the throttle opens. Voltage should be near 5.0 volts at Wide Open Throttle (WOT).
The Powertrain Control Module (PCM) has the ability to auto-zero the Throttle Position (TP) sensor voltage if it is below about 0.90 volt
(900mV). This means that any voltage less than 0.90 volt will be determined by the PCM to be 0% throttle. A scan tool also has the ability to
display the throttle angle and should display 0% when the throttle is closed, and increase smoothly to 100% at WOT. A fault in the TP sensor or
circuit should set a DTC P0122 or P0123. A "stuck" sensor will set a DTC P0121. See: Testing and Inspection
