pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Ignition Key and Lock Cylinder - Revised|Page 3764 > < Starting - Revised Procedures for Inop Ignition Cylinder|Page 3759
Page 1
background image

Ignition Switch Lock Cylinder: All Technical Service Bulletins
Ignition Key and Lock Cylinder - Revised

File In Section: 3 - Steering/Suspension

Bulletin No.: 43-32-09

Date: December, 1994

Subject:
Ignition Key and Lock Cylinder Change

Models:
1995 Buick Skylark 
1995 Chevrolet Cavalier 
1995 Oldsmobile Achieva 
1995 Pontiac Grand Am, Sunfire

General Motors has made styling and design enhancements to the ignition keys and lock cylinders. This change increases the shoulder length by 3 mm
and removes the notch in the key blank.

The old key blank, P/N 26038483, can be used on the 1994 N car. A new interchangeable key blank, P/N 26049133, is being released for the 1994-95 N
and 1995 J car.

The old key blank is being discontinued. Use old key blank on 1994 N car only.

The illustration shows the difference between the old key and the new key.

Key Cutter Parts Information

There is no need to change key cutter equipment. If there is difficulty cutting ignition keys, please contact your local key cutter representative. Two
suppliers are listed below, however, other suppliers may be contacted on an individual basis.

Ignition Key and Lock Cylinder - Revised|Page 3764 > < Starting - Revised Procedures for Inop Ignition Cylinder|Page 3759