Sunfire L4-138 2.3L DOHC VIN D MFI (1995)
7.
Remove two screws (7 mm hex head) from accessory/radio trim plate. Carefully remove trim plate by rotating and pulling out. See figure 4.
8.
Remove topper pad as follows: rotating and pulling out. See figure 4.
^
Two 7 mm hex screws (gold/brass colored) forward of supplemental inflatable restraint (SIR) panel.
IMPORTANT:
THE GOLD/BRASS COLORED SCREWS MUST BE REINSTALLED INTO THE SAME FASTENER LOCATIONS AT THE FRONT OF THE
SIR PANEL.
^
Four 7 mm hex (or T15 torx) screws (black) from lower rear edge of pad.
^
Four 7 mm hex (or T15 torx) screws (black) from upper forward edge of pad.
^
Carefully remove topper pad by pulling away from I/P.
