Sunfire L4-144 2.4L DOHC VIN T SFI (2001)
sticky backing. Foreign material may cause improper adhesion.
1. Clean the area where the emblem/nameplate will be installed.
Use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a (50/50 mixture) by volume of isopropyl alcohol and water in order to
clean the area.
2. Dry the area thoroughly.
3. If the location of the emblem/nameplate has not been marked, apply tape and use the following dimensions:
*
Dimension "A" is 57 mm (2 1/4 in) from the front edge of the door to the emblem.
*
Dimension "B" is 26 mm (1 1/32 in) is the gap between the Sunfire and the GT.
*
Dimension "C" is 39 mm (1 1/2 in) is the distance from the molding to the emblem.
4. Heat the mounting surface to approximately 27-41°C (80-105°F).
5. Ensure that the temperature of the emblem/name plate is approximately 29-32°C (85-90°F).
6. Remove the protective liner from the back of the emblem/name plate.
7. Position the emblem/name plate to the location marks and press the emblem/name plate to the mounting surface.
8. Apply equal pressure along the emblem/name plate in order to uniformly bond the item to the mounting surface.
9. Remove the protective tape from the mounting surface.
Emblem/Nameplate Replacement (Sunfire)
Emblem/Nameplate Replacement (Sunfire)
Tools Required
J 25070Heat Gun
Removal Procedure
1. When replacing or repairing an emblem/nameplate do the following:
1. Use tape to protect the mounting surface during removal.
2. Use tape for alignment marks for installation of the emblem/nameplate.
2. To remove an emblem/nameplate, heat the emblem/nameplate using a J 25070.
Apply heat using a circular motion for about 30 seconds.
