Sunfire L4-144 2.4L DOHC VIN T SFI (2001)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Pressure Modulator Valve (BPMV) Replacement
Brake Pressure Modulator Valve (BPMV) Replacement
Removal Procedure
Caution: For safety reasons, the brake pressure modulator valve assembly must not be repaired, the complete unit must be replaced. With
the exception of the EBCM, no screws on the brake pressure modulator valve assembly may be loosened. If screws are loosened, it will not be
possible to get the brake circuits leak-tight and personal injury may result.
1. Turn the ignition switch to the OFF position.
2. Disengage the Connector Position Assurance (CPA) (2) from the connector.
3. Push the lock tab (1) down and then move the sliding connector cover to the open position.
4. Disconnect the Electronic Brake Control Module (EBCM) harness connector (4).
Important: Note the locations of the brake pipes in order to aid in installation.
