Sunfire L4-144 2.4L DOHC VIN T SFI (2001)
3. Install the caliper (2) over the rotor into the knuckle.
Tighten
Tighten the mounting bolt and sleeve assemblies to 51 Nm (38 ft. lbs.).
4. Install the inlet fitting (5).
Tighten
Tighten the inlet fitting to 44 Nm (32 ft. lbs.).
5. Perform the following steps in order to install the wheel and tire, aligning the previous marks:
5.1. Remove the wheel nuts securing the rotor to the hub and bearing assembly.
5.2. Install the wheel and tire assembly with the retaining nuts in the proper sequence.
5.3. Lower the vehicle.
6. Bleed the hydraulic brake system.
7. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
8. Slowly release the brake pedal.
9. Wait 15 seconds, then repeat steps 7 and 8 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
10. Fill the master cylinder to the proper level with clean brake fluid.
