Sunfire L4-144 2.4L DOHC VIN T SFI (2001)
14. Install ignition coil and module assembly.
Important: Do not compress the lifter plungers using a vise or other tool. This will cause more air enter the lifter assembly and will take more time to
bleed out once the lifters are installed.
15. If new lifters have been installed or the lifters bled down while the engine was disassembled, excessive lifter noise may be experienced. This is a
normal condition and no engine damage is occurring. Use the following procedure to purge air from the lifters:
15.1.
Start the engine and allow the engine to warm up at idle for 5 minutes
15.2.
Increase the engine speed to 2,000 RPM until the lifter noise is gone.
15.3.
Return the engine to idle for an additional 5 minutes or perform a road test.
16. Connect the negative battery cable.
