Sunfire L4-144 2.4L DOHC VIN T SFI (2001)
Throttle Position Sensor: Service and Repair
THROTTLE POSITION (TP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the air cleaner outlet resonator.
2. Remove the Throttle Position (TP) sensor attaching screws (1).
3. Remove the TP sensor (2) and seal (3).
INSTALLATION PROCEDURE
1. With the throttle valve in the normal closed (idle) position, install the throttle position sensor (2) and seal (3) on the throttle body assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: Install the new TP sensor attaching screws when replacing TP sensor.
2. Install two TP sensor screws (1).
Tighten
Tighten the screws to 2 N.m (18 lb in).
3. Install the air cleaner outlet resonator.
