Sunfire L4-144 2.4L DOHC VIN T SFI (2001)
Disclaimer
Information
1.
Open the hood.
2.
Check the battery state of health using the J 4200 Midtronics Digital Battery Tester or suitable equivalent. If the tester displays "Replace Battery",
attach a battery charger to the battery while performing this repair, as the test at the end will require cranking/starting the engine six times in
succession. A low battery state of charge may affect the outcome of the test.
Important:
If the battery fails the test (does not have sufficient reserve capacity or cold cranking amps required), the customer should be advised that the
battery is not functioning properly and should be replaced. The customer should be informed that battery replacement is not covered under this
recall, and that a replacement battery may be purchased from the dealership or another source.
3.
Disconnect the negative battery cable.
Caution
The oil filter, exhaust manifold, and exhaust pipe may be hot. Use care to avoid personal injury.
1998 N Car - Achieva/Grand AM/Skylark with 3.1L V6 (VIN Code M)
1998 N Car - Achieva/Grand Am/Skylark with 3.1L V6 Engine (VIN Code M)
1.
Locate the round hole located in the small depressed area in the back side of the radiator support upper bar just to the right (passenger side) of the
air bag sensor mounting bracket and install the J-nut included in the harness kit.
2.
Attach the relay bracket (1) on the harness kit to the radiator tie bar (2) using the J-nut previously installed and the shorter hex head bolt (with the
washer) included in the kit.
Tighten
Tighten the bolt to 10 Nm (89 lb in).
3.
Locate the short black wire with a ring terminal on one end from the harness kit.
4.
Using the longer hex head bolt (without the washer) included in the kit, attach the ring terminal to the weld nut located on the top surface of the
