Sunfire L4-144 2.4L DOHC VIN T SFI (2001)
39.
If equipped, remove the 10 mm hex head nut from the ground stud on the engine block. If no ground stud is present, remove one of the bolts (2)
that attach the starter solenoid (1) to the starter motor.
40.
Install the ground ring terminal (black wire) on the harness kit on the ground stud or solenoid bolt. Install the nut on the stud.
Tighten
Tighten the bolt to 9 Nm (80 lb in).
41.
Install the starter to the engine and install the lower bolt finger tight. Do not tighten at this time.
42.
Lower the vehicle.
43.
Install the upper starter bolt.
Tighten
Tighten the bolt to 90 Nm (66 lb ft).
44.
Raise the vehicle.
45.
Tighten the lower starter bolt.
Tighten
Tighten the bolt to 90 Nm (66 lb ft).
46.
Install a new oil filter.
47.
Lower the vehicle.
48.
Remove the rubber seal from around the top of the throttle body and install it on the bottom of the air cleaner outlet resonator.
49.
Position the air cleaner outlet duct and resonator over the throttle body and install the hose to the bottom of the resonator.
