Sunfire L4-144 2.4L DOHC VIN T SFI (2001)
Installation Procedure
1. Install the tie rod end (3) to the inner tie rod shaft (1).
2. Install the outer tie rod ball stud (4) to the steering knuckle (6).
Notice Refer to Fastener Notice in Service Precautions.
3. Install the new prevailing torque nut (5) to the outer tie rod ball stud (4).
-
Tighten the new prevailing torque nut to 45 Nm (33 ft. lbs.).
4. Install the front tire and wheel. Refer to Tire and Wheel Removal and Installation.
5. Adjust the front toe. Refer to Front Toe Adjustment.
6. Tighten the jam nut (2).
-
Tighten the jam nut to 75 Nm (55 ft. lbs.).
Rack and Pinion Boot Replacement-On Vehicle
-
Tools Required
-
J22610 Service Boot Clamp Installer
Removal Procedure
1. Remove the outer tie rod. Refer to Tie Rod End Replacement-Outer.
2. Remove the nut (5) from the inner tie rod assembly.
3. Remove the tie rod clamp (4).
4. Use side cutters to remove the boot clamp (2).
5. Discard the boot clamp.
6. Remove the rack and pinion boot (3).
Installation Procedure
