Sunfire L4-144 2.4L DOHC VIN T SFI (2001)
Windshield Washer Switch: Service and Repair
Standard Column
Removal Procedure
1. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement-On Vehicle.
2. Remove the multifunction switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement-On Vehicle.
3. Remove the 2 retaining head screws from the windshield wiper switch (2).
4. Remove the windshield wiper switch (2) from the column (6).
5. Disconnect the electrical connector from the windshield wiper switch.
Installation Procedure
1. Connect the electrical connector to the windshield wiper switch (2).
2. Install the windshield wiper switch (2) to the column (6).
Notice Refer to Fastener Notice in Service Precautions.
3. Install the 2 retaining screws to the windshield wiper switch (2).
-
Tighten the screw to 4 Nm (36 inch lbs.).
4. Install the multifunction switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement-On Vehicle.
5. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement-On Vehicle.
6. Ensure that the windshield wiper switch (2) functions properly.
