Sunfire L4-2.2L VIN 4 (1996)
(Manual Transaxle)
Figure 3
1.
Protect adjacent components using a weld resistant blanket.
2.
From above, locate and grind out existing welds on top edge of left rear bracket.
3.
MIG weld top edge of left rear bracket to the surface of the rail.
4.
Raise vehicle and weld remaining areas from below.
5.
Protect components with a weld resistant blanket: CV boots and brake lines.
Important:
The left rear mount is a two-piece assembly. If repairs are necessary, grind out existing welds with a burr wheel/cutter or equivalent. Grind out
WELD ONLY and re-weld entire perimeter.
6.
Prepare welds for replacement as indicated above.
7.
MIG weld edge of bracket continuously to extension as shown in Figure 3.
8.
Clean and prepare all welded surfaces for painting.
9.
Primer and topcoat welded surfaces.
LH Front Transaxle Mount
(Manual Transaxle)
