Sunfire L4-2.2L VIN 4 (1996)
Alarm Module: Technical Service Bulletins
Multifunction Alarm Module - Location Revision
File In Section: 8 - Chassis/Body Electrical
Bulletin No: 53-83-22
Date: November, 1995
SERVICE MANUAL UPDATE
Subject:
Section 8C - Revised Location of the Multi-Function Alarm Module
Models:
1996 Chevrolet Cavalier
1996 Pontiac Sunfire
This bulletin is to revise the information in the Service Manual concerning the "Multi-Function Alarm Module". The location of the Multi-Function
Alarm Module should be updated in Section 8C2-15, Cell 8A-76 and Cell 8A-114. The Multi-Function Alarm Module is now located on the right hand
side of the vehicle, under the Instrument Panel Assembly (see Figure 1). Included are the procedures for replacement of the Multi-Function Alarm
Module.
Remove or Disconnect
1.
Negative battery cable.
2.
Right sound insulator.
3.
Nut holding the Multi-Function Alarm Module (see Figure 1, Item 3).
4.
Two electrical connections from module (see Figure 1, Item 2).
5.
Multi-Function Alarm Module from vehicle (see Figure 1, Item 1).
Install or Connect
1.
Two electrical connectors to the Multi-Function Alarm Module (see Figure 1, Item 2).
2.
Multi-Function Alarm Module to vehicle with nut (see Figure 1, Item 3).
3.
Right sound insulator.
4.
Negative battery cable.
Diagnostic Information
When placing the Multi-Function Alarm Module into the Power Output Diagnostic Mode, the park brake must first be engaged to disable the daytime
running lights. Failure to do so will prevent the Multi-Function Alarm Module from entering the Power Output Diagnostic Mode.
