Sunfire L4-2.2L VIN 4 (1996)
Figure 4
1.
Locate and grind out existing welds that secure bracket to rail and bracket to extension.
2.
MIG weld all mating surfaces that were previously prepped.
3.
Install an additional weld, SEE BOTTOM HALF OF FIGURE 4. This weld will extend the full length of the bracket. Use a clamp to ensure that
bracket is positioned flush with the rail.
4.
From the wheelhouse area, prepare joint for welding.
5.
From the wheelhouse area, apply the additional weld to bracket as shown in Figure 4.
6.
Clean and prepare all welded surfaces for painting.
7.
Primer and topcoat welded surfaces.
Install or Connect
1.
Remove blocks and shift motor to correct position.
2.
Install mount on right side of motor (3 bolts), torque to Service Manual specs. Use Goodwrench threadlocker on mount bolts.
3.
Install left motor mount assembly.
4.
Install right motor mount assembly.
