Sunfire L4-2.2L VIN F (2002)
Rear Door Panel: Service and Repair
Panel Replacement
Trim Panel Replacement - Side Rear Door
Tools Required
J 38778 Door Trim Pad and Garnish Clip Remover
Removal Procedure
1. Remove the power window switch, if equipped.
2. Remove the window manual regulator handle, if equipped.
3. Remove the armrest bolt (1).
4. Using J 38778 and starting at the door bottom, disengage the door trim panel (2) retainers.
5. Remove the door trim panel (2) from the door by lifting up on the panel to disengage the inner belt weatherstrip.
Installation Procedure
1. Position the rear door trim panel (2) to the door, pressing down to seat the inner belt weatherstrip.
2. Align the push-in retainers and push in to engage the retainers.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the door armrest bolt (1).
Tighten the armrest screws to 3 N.m (27 lb in).
