Sunfire L4-2.2L VIN F (2002)
3. If the location of the emblem/nameplate has not been marked, apply tape and use the following dimensions:
4. For the SUNFIRE emblem/nameplate, install to the following dimensions:
*
Dimension (a) is 57 mm (2.250 in) from the front edge of the door to the front of the emblem/nameplate.
*
Dimension (b) is 39 mm (1.500 in) from the top of the door molding to the bottom of the emblem/nameplate.
5. For the SUNFIRE GT emblem/nameplate, install to the following dimensions:
*
Dimension (a) is 57 mm (2.250 in) from the front edge of the door to the front of the emblem/nameplate.
*
Dimension (b) is 26 mm (1.024 in) between the SUNFIRE and the GT emblem/nameplate.
*
Dimension (c) is 39 mm (1.535 in) from the top of the door molding to the bottom of the emblem/nameplate.
6. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070, if necessary.
7. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).
Important: Do not touch the adhesive backing on the emblem/nameplate.
8. Remove the protective liner from the back of the emblem/nameplate.
9. Position the emblem/name plate to the location marks and press the emblem/nameplate to the mounting surface.
10. Apply equal pressure along the emblem/name plate to uniformly bond the item to the mounting surface.
11. Remove the protective tape from the mounting surface.
Emblem/Nameplate - Front Fender
Emblem/Nameplate Replacement - Front Fender
Tools Required
J 25070Heat Gun
Removal Procedure
1. When replacing an emblem/nameplate, do the following:
1. Use tape to protect the mounting surface during removal.
2. Use tape for alignment marks for installation of the emblem/nameplate.
