Sunfire L4-2.2L VIN F (2002)
timing may cause damage to the sunroof system. Close the window panel whenever you remove the sunroof actuator from the sunroof module
assembly.
1.
Clip the tie straps and remove the express module by sliding it towards the motor to unlock it from the slots provided in the module.
2.
Disconnect the wire harness from the express module, power supply, and switch.
3.
remove the sunroof motor/actuator bolts(2) from the sunroof motor/actuator.
4.
Remove the sunroof motor/actuator from the sunroof module.
5.
Remove the sunroof glass.
6.
Make sure the sunroof lift arms are aligned by inserting a pin in the front sunroof glass attachment hole to the lift arm cam. If you can insert a large
paper clip through the two, it is aligned. Refer to the illustration above.
7.
If the arms are not aligned, push the arms with a screwdriver at the location shown. Refer to the illustration above.
Important:
Before you install a new sunroof motor/actuator or re-install the old actuator to the sunroof module, ensure that the actuator is timed to the
closed position.
8.
Verify that the original sunroof motor/actuator or the new sunroof motor/actuator is timed to the closed position by preforming the following steps:
